This applicator is ideal for cleaning sections from 6 to 28 mm.
Equipped with double tip. The chisel tip is suitable for cleaning the outside surfaces and the round tip facilitates deep cleaning of the inner surface.

Instructions for the Applicator
Before using the product, load the applicator: break the vial, remove the chisel tip only and pour the contents of the vial. Replace the tip and position the applicator horizontally for a few seconds before cleaning. Distribute the product on the surface to be cleaned by simple rubbing, without pressure. Use the chisel tip for the outside and the round tip for the inside of the part to be cleaned.

How to keep the applicator
The applicator is a tool. After use, place the tool perfectly sealed. After charging the product, charge as shown above.

Dispose as undifferentiated.

The tips are spare parts and should be replaced when they lose their original shape.

Pipe applicator for cross section greater than 28mm.
Equipped with a chisel tip to clean internal and external surfaces. The particular oblique shape facilitates deep cleansing of the “glass”.

Instructions for the Applicator
Before using the product, load the applicator: break the vial, extract the tip and pour the vial contents. Replace the tip and position the applicator horizontally for a few seconds before cleaning. Distribute the product on the surface to be cleaned by simple rubbing, without pressure

How to keep the applicator
The applicator is a tool. After use, place the tool perfectly sealed. After charging the product, charge as shown above. Dispose as undifferentiated.

The tip is a spare part and needs to be replaced when it loses its original shape.